Posts by Hypneumat Inc.
Right-Angle Milling Head
Shown here is a Hypneumat M350EHB unit with a right-angle milling head. The unit is powered by a 1.5 HP 1762 rpm brake motor and includes a push type hydra-brake and spindle positive stop.
Read More10” Stroke Drilling Units
Here are four Hypneumat DQ310EHB drilling units with ER40 spindles and 2 HP 3600 rpm motors. The motors are mounted using our motor mount belt guard. Per customer’s request, the units have 10” of stroke, silicone-filled hydra-brakes, sealed bearings, and oversized ports.
Read MoreFX34 with Counterbalance
The Hypneumat FX34 Ball Screw Rail Unit has 4” of stroke, is equipped with a 1-3/8” straight bore spindle, a counterbalance, and has servo motors for the linear feed and spindle speed. This auto-feed unit will perform a tapping operation. The servo motors allow for programmable synchronous control between the axial feed and spindle speed.
Read MoreBillet Style 4-Spindle Head
Hypneumat made this custom billet-style 4-spindle multi-head for a customer’s application. This head is powered by a Hypneumat DQ46EHB auto-feed drilling unit.
Read MoreDual Tapping LS46E Units
This Hypneumat Machine uses two opposing heavy duty LS46E leadscrew tapping units with floating tap holders and is wired with full controls, ready for the customer to mount their part holding fixture.
Read MoreDQ500 and Commander 4-36
This Hypneumat DQ56EHB drilling machine drives an 8-spindle Commander 4-36 multi-head. The machine rests on a 54” by 48” table and uses a 5 HP 1200 rpm motor.
Read MoreM200EHB with Air Motor
Shown here is one of our M200EHB series drilling units with a 1 HP 2000 rpm Gauss air motor. Air motors were utilized for this application because of their smaller motor frame allowing for multiple units to be mounted in line to drill close-center holes. This unit has a 2” stroke and ER25 collet spindle…
Read MoreCommander 8-12 with Adjustable Spindles
This Commander 8-12 series multiple-spindle head has 12 universal joint spindles. These collet style spindles can be adjusted for different hole patterns.
Read MoreThree M Units with Tight Pattern
These three M-series (direct drive) units with varying lengths are capable of drilling holes at closer centers that would not otherwise be possible with our standard auto feed drilling units. The center unit has an extended rear housing so the 1 HP, 3600 rpm motors are staggered, and the drilling units can be mounted closer…
Read MoreDQ46EHB with Quill Stabilizer
A Hypneumat Quill Stabilizer option can be added to our auto feed drilling units allowing for a rigid tool feed to offset high side load applications. This also provides an accurate and concentric tool feed for tight tolerance drilling and reaming operations. The Quill Stabilizer can be provided on any series of Hypneumat quill feed…
Read More